2 ½" Executive Face Plate Only

Waterway Executive hot tub pump series wet end faceplate with 2-1/2" suction inlet. **Details:** - Waterway part #311-1210 - Made in the USA by Waterway Plastics - Actual measurement of the intake is approximately 3-5/8" O.D, - Faceplate does not include drain plugs, barb fittings, or o-rings. - Drain plugs with o-rings are sold separately if required. - Some pumps may have a small hose instead of one of the drain plugs which would require an additional barb fitting **Important.** - Fits Waterway Executive series pump models with first 7 digits of serial numbers starting from PF10277... and up, will not fit pumps with lower serial numbers. Pumps with lower serial numbers would need a complete replacement wet end as these parts may not fit. Will not fit any Waterway EX2 series pumps or any other spa pump brands. - Waterway changed the design of this faceplate in late 2017. The part number remains the same however the new design requires TWO large o-rings instead of the old design which only used one. The faceplate o-rings are not included, part #805-0261 is sold separately and this faceplate requires a total of TWO.