Balboa BP100 Bundle with TP200 Keypad

**Single Pump System with TP200T Topside Control:** operates a 2-spd Pump & optional Circulation Pump (Pump 1 becomes a 1-spd circuit when circ pump used). - Main Pump Circuit (2-Speed) - 110V or 220V 12A Max\* - Ozonator Circuit - 110V or 220V (Must match voltage of circulation pump circuit below. If you do not have a small circulation pump, you have the option to set this circuit to either voltage. If you have a small circulation pump, you must use an ozonator with the same voltage as your circulation pump.) - Light Circuit - 12 Volts - **\*\***Circulation Pump Circuit - 110V or 220V. Circ and Ozone must be same voltage - Audio/Video circuit, 110/220V, 2A Max (Constant Circuit) - Includes one 2-speed cord - Topside measures 4-3/8” x 1-1/2” These control systems can be wired to 220 Volts or 110 Volts. If wired to 220 Volts, each of the component circuits can be either 220V or 110V. 220V requires 4 wires (Neutral required). - 4.0KW Flo-Thru heater on 240V (1 kW on 120V) with M7 technology - Program Setting from Compatible Balboa Topside Panel - Wifi Enabled (Balboa Wifi Module Sold Separately) - Stainless steel heater housing - Quick Disconnect Heater Cable - Freeze protection, High-limit protection, Filtration mode, Economy Mode **\*\***Most spas don't have a small circulation pump, instead, the main pump runs on low speed to heat and filter the water during set filtration cycles. If you are using a small circulation pump, the flow rate must be at least 25 gallons per minute. In other words, the circulation pump must be similar to a **Waterway Iron Might** or **Aquaflo Circmaster Pump** and require a minimum 1.5" size plumbing. **Pumps like the Waterway Tiny Might or Laing E10 Circulation Pump are too small and will not work with this control system.** **Includes an adapter plate for the topside control.** Use if you previously had a larger topside and you need to cover a larger hole. The adapter plate has double-sided sticky tape on back.